Showers consist of a preformed device produced from gel-coated fiberglass. Unlike installing soap dishes in shower partitions, which needs drilling screw-holes through tile and to the wall or dry wall studs, fiber glass showers have soap dishes. This is because fiber glass shower partitions can crack and are not strong enough to withstand drilling or strengthened, which might be costly to repair. Rather than using screws to install a soap dish, glues are employed to affix it to the fiber glass shower wall.

Adhesive Backing

Clean the fiber glass let them air-dry and shower partitions.

Measure 16-inches below the showerhead on the wall. Measure 8 to 10″ to the right or left from the 16-inch stage and spot a bit of masking tape. This can be where the soap dish will soon be installed. When you install a soap dish using a removable adhesive having a pulltab, the soap dish A15-inch area beneath it for one to be in a position to pull down the tab and eliminate the adhesive.

Wipe down the area where you put the tape with a cloth as well as rubbing alcohol.

Remove the liner in the adhesive strip on the soap dish. Press the strip, when it’s not already installed and eliminate the 2nd liner from the adhesive strip.

Remove the tape in the shower wall. Press and hold and hold the back of the soap dish it.

Wait one hour before using the shower.

Shower Wall Adhesive

Measure 16-inches below the showerhead on the wall and then 8 to 10″ up to to the -inch level on the wall. Mark this place using a bit of tape. This can be where the soap dish is to be installed.

Put on a breathing apparatus to avoid inhaling safety eyeglasses and microscopic fiber glass fibers. In a patch, sand the the top of fiber glass shower wall the dimensions of the again of the soap-dish mount, devoted to where the tape was positioned by you. Wipe the region using a micro-fiber fabric to eliminate the sanding dirt down.

Apply a bead of fiber glass adhesive across the perimeter of the again of the soap-dish mount.

Press the mount contrary to the wall to transfer a few of the adhesive about it it. Remove the mount and wait three full minutes minutes for the adhesive to partly established.

Press the soap dish mount from the wall. Wait 3 minutes and press the soap dish from the wall to make sure that it sticks.

Wait 2 4 hours before utilizing the shower to enable the soap dish adhesive set or to totally cure.