A three-prong washer cord consists of a ground wire, a hot-wire as well as a white wire. Unlike 220 Volt dryer cord, a washer will use a 220-volt outlet. Unlike a dryer cord, which can be mounted close to the base of the device, nevertheless, a washer power cord is mounted large enough to prevent any possibility of getting damp. Under the the control panel, the connection is going to be positioned typically and can require some disassembly.
Unplug the cord in the outlet.
Remove the screws that hold the control-panel on using a screwdriver. Generally, the screws will be Phillips-head and can be positioned on the sides of the washer. On some versions before it is possible to attain access, a rubber look cap will require to be eliminated. Pry the caps off with a -head screw-driver. When the screws are removed, flip the control-panel cover up. They’re usually attached to hinges, plus they flip-up from front to back.
As it comes to the control panel location, locate the cord. It can be secured using a clip or a rubber grommet. On some versions the cords will have the black/green wires exhibiting. In the back to to find the wires which can be moving, wiggle the cord on kinds. The wires will likely be connected to the washer using a collar that is plastic.
Where the strength cord attaches to the washer cord unhook the collar. The washer cord is basically attached by the strength cord to the electronics of the washer. With regards to the model, there might be a hook-re lease that that should be be pried up, a button on the medial side that when pushed releases the plug, or a blend of the two in the event the wires are linked together.
Release the rubber grommet that retains the cord in position or the clip. The clip will possess a latch on along side it that’s pushed in using a screwdriver release a. Fitting snugly attach a rubber grommet inside the accessibility hole. It wants to be pried out using a screwdriver. Pull the cord from the again of the washer once it really is introduced.
Insert the cord to the hole where the aged plug arrived on the scene. It’s going to enter in the rear of the control-panel. Push the cord through the attachment hole and secure both the plastic clip in position by pushing it through the hole till it locks, or secure the grommet in the attachment hole by cautiously pushing it through till it seats it self along the edges of the hole, similar to a plug seats it self in to a drain.
Connect the connections. An individual plug will only plug-in a single way. Connectors will suit the connector that is correct for that wire. Near the control panel protect, after the gadget is related and screw it down with all the screws.